03 - Sealing the edge moldiing

Previous Image | Next Image
Description: You can lay the standard Eternabond under your moldings and then screw them down.  No need for any tube caulking.  

The aluminum backed tape molds easily to irregular surfaces so I ran it over the top edges of the molding right over the screws and then smoothed it down for a good seal.

Not only did I do the side edges, but I also ran the tape around the bases of all the roof fixtures.

If you make a mistake, you can scrape the Eternabond tape off with a putty knife and remove the rest with a rag soaked in gasoline.

Note:  I cleaned and applied the Eternabond tape to the edging before cleaning the rest of the roof  because I didn't want the hose nozzle pressure to force water under them.

Picture Stats:
Views: 6881
Filesize: 39.9kB
Height: 338 Width: 450
Keywords: roof  re-seal  repair  leak 
Posted by: Oz at July 13, 2009, 07:38 PM

Image Linking Codes
BB Code
Direct Link
Show Html Link Code

Comments (0)



Powered by: SMF Gallery