Started by eXodus, December 14, 2022, 06:25 AM
0 Members and 1 Guest are viewing this topic.
Quote from: DaveVA78Chieftain on December 25, 2022, 01:21 PMAll I can say is if the original circuit is like the ones in the drawings, then at the Brake Light switch the three post portion should be the portion your looking for with the following three wires in that three post connector:Orange (circuit 140) from fuseBlue (Circuit 20) for 3rd brake light (isolated from hazard switch when brake is resting)White (Circuit 17) for turn signal switch, cruise control, etc.
Quote from: eXodus on December 24, 2022, 07:17 AMGerman Electrical Engineer - thinking difficult is my specialty
Quote from: Mlw on December 22, 2022, 12:57 PMQuote from: eXodus on December 20, 2022, 06:47 PMWiring to the brake lights is just a half measure - yes it works - but as soon you burn out a both brake light - the brake controller also stops working - not a good solution.Are you not thinking too difficult Exodus?
Quote from: eXodus on December 20, 2022, 06:47 PMWiring to the brake lights is just a half measure - yes it works - but as soon you burn out a both brake light - the brake controller also stops working - not a good solution.
Quote from: eXodus on December 14, 2022, 07:08 PMthe brakes are pulsing with the lights. So there must be somehow power from the hazard switch flowing where the brake controller ties into Stop light switch. Maybe a Diode would fix it, but I don't want to cut cables and put in random diodes