New Alternator. Still not charging

Started by Kittykat0505, August 07, 2016, 11:12 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

DaveVA78Chieftain

The charging portion works like shown in this diagram:





The I1 in that drawing is the "Run" in the following drawing
The I2 in that drawing is the "Start" in the following drawing
The S in that drawing does exist and is the actual "Start" to the relay.  2 start signals are used because the power at the ballast resistor in run would keep the starter engaged if there was not.




[move][/move]