Classic Winnebagos & Vintage RVs

Topic Boards => Coach => Topic started by: HVACguy on April 08, 2017, 08:12 PM

Title: Trying to get Water plumbing right
Post by: HVACguy on April 08, 2017, 08:12 PM
Decided it was warm enough to attempt to get the water working for the first time, so I hooked up hose and regulator in driveway, and turned it on. I have water pouring out of one of two white hoses that appear to purposely terminate right above the frame behind the rear wheels drivers side, right below the bathroom area. I am guessing this is some type of drain, but the only drains I can find are one under the rear bed near pump, and one under bathroom sink. Both of these are little pull ring that pull or push ( i have them both pushed in) and they are on much smaller grey plastic lines. This is a 1989 Winn. Warrior. Any suggestions would be appreciated
Title: Re: Trying to get Water plumbing right
Post by: DaveVA78Chieftain on April 08, 2017, 10:39 PM
Looking at the Warrior Brochures for 1989 and 1990 they seem fairly close.  The 1990 plumbing diagram may be of help

WCF22EC (http://www.winnebagoind.com/diagram/1990/F22EC.pdf)

WCF27EU (http://www.winnebagoind.com/diagram/1990/F27EU.pdf)