Trying to get Water plumbing right

Started by HVACguy, April 08, 2017, 08:12 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

HVACguy

Decided it was warm enough to attempt to get the water working for the first time, so I hooked up hose and regulator in driveway, and turned it on. I have water pouring out of one of two white hoses that appear to purposely terminate right above the frame behind the rear wheels drivers side, right below the bathroom area. I am guessing this is some type of drain, but the only drains I can find are one under the rear bed near pump, and one under bathroom sink. Both of these are little pull ring that pull or push ( i have them both pushed in) and they are on much smaller grey plastic lines. This is a 1989 Winn. Warrior. Any suggestions would be appreciated

DaveVA78Chieftain

Looking at the Warrior Brochures for 1989 and 1990 they seem fairly close.  The 1990 plumbing diagram may be of help

WCF22EC

WCF27EU
[move][/move]