Classic Winnebagos & Vintage RVs
Topic Boards => Topics for all Chassis => Topic started by: srosa707 on April 20, 2018, 04:40 PM
While looking under my D20 last summer I found this SUPER SKETCHY frame extension piece. Is this factory or homemade?
That was definitely added by Winnebago and they should be ashamed!! Personally, I would be upgrading that before I did any towing.
THAT right there is why I am always harping on the towing limits of the Winnebago. That is from the Winnebago factory, They get a standard length chassis from GM.
A good welder can reinforce that properly pretty easily and cheaply. I would do it even if your not towing.
That is scary that the factory would cobble something together like that and pass it off as usable! I've got a buddy with a D18 who owns a fabrication shop that will be building a rear section for both of our rigs. I might have him do something for the front bumper, too. Ill report back when its done (Winter '18 project?).
They knew it wasn't adequate. Mine has a factory hitch receiver. It also has a sticker that says not to tow anything. Apparently the receiver is just meant to mount a bicycle rack or some such thing.